How to Fix Ariston 103 Fault Code (No Circulation - Low Dt) UK
Ariston 103 means no circulation - low DT. UK diagnosis, parts to order, reset sequence.
What 103 means
Ariston 103 indicates no circulation - low DT. The boiler will lock out and refuse to fire until the fault is cleared.
Do not simply reset — 103 is stored in the Ariston error log and will re-trigger within minutes if the underlying part has failed.
Diagnostic sequence
Enter service mode on the Ariston boiler and read the flow/return/DHW temperatures, fan PWM, ionisation current and pump speed.
Cross-reference against the Ariston technical manual — 103 typically points to two or three candidate parts.
- Check wiring harness continuity to the suspect sensor before condemning it.
- Isolate at the fused spur, discharge and re-inspect connectors.
- Measure resistance / voltage at the PCB plug per Ariston test procedure.
Parts to have on the van
Carry a set of NTC sensors, an ignition electrode kit and a fan for Ariston — these three parts clear >70% of 103 call-outs.
Recommission
After the fix, run the Ariston boiler through a full flow test, gas rate, and combustion analysis. Log to the Benchmark book to preserve manufacturer warranty.
Frequently asked questions
- Can I reset 103 without changing parts?
- Only if the fault has cleared (e.g. low pressure repressurised). Persistent 103 means a hardware failure.
- Which is the most common cause of Ariston 103?
- On Ariston boilers, 103 most often points to the sensor or actuator matching its meaning (no circulation - low DT); check wiring and connector integrity first.
- Is a Gas Safe engineer required?
- Yes — any works past the boiler case seal require a Gas Safe registered engineer under UK law.
Browse boiler spares — 14,820 live parts.
View Boiler Spares