How to Fix Baxi E117 Fault Code (High Water Pressure) UK
Baxi E117 means high water pressure. UK diagnosis, parts to order, reset sequence.
What E117 means
Baxi E117 indicates high water pressure. The boiler will lock out and refuse to fire until the fault is cleared.
Do not simply reset — E117 is stored in the Baxi error log and will re-trigger within minutes if the underlying part has failed.
Diagnostic sequence
Enter service mode on the Baxi boiler and read the flow/return/DHW temperatures, fan PWM, ionisation current and pump speed.
Cross-reference against the Baxi technical manual — E117 typically points to two or three candidate parts.
- Check wiring harness continuity to the suspect sensor before condemning it.
- Isolate at the fused spur, discharge and re-inspect connectors.
- Measure resistance / voltage at the PCB plug per Baxi test procedure.
Parts to have on the van
Carry a set of NTC sensors, an ignition electrode kit and a fan for Baxi — these three parts clear >70% of E117 call-outs.
Recommission
After the fix, run the Baxi boiler through a full flow test, gas rate, and combustion analysis. Log to the Benchmark book to preserve manufacturer warranty.
Frequently asked questions
- Can I reset E117 without changing parts?
- Only if the fault has cleared (e.g. low pressure repressurised). Persistent E117 means a hardware failure.
- Which is the most common cause of Baxi E117?
- On Baxi boilers, E117 most often points to the sensor or actuator matching its meaning (high water pressure); check wiring and connector integrity first.
- Is a Gas Safe engineer required?
- Yes — any works past the boiler case seal require a Gas Safe registered engineer under UK law.
Browse boiler spares — 14,820 live parts.
View Boiler Spares