How to Fix Ideal F6 Fault Code (Outdoor Sensor) UK
Ideal F6 means outdoor sensor. UK diagnosis, parts to order, reset sequence.
What F6 means
Ideal F6 indicates outdoor sensor. The boiler will lock out and refuse to fire until the fault is cleared.
Do not simply reset — F6 is stored in the Ideal error log and will re-trigger within minutes if the underlying part has failed.
Diagnostic sequence
Enter service mode on the Ideal boiler and read the flow/return/DHW temperatures, fan PWM, ionisation current and pump speed.
Cross-reference against the Ideal technical manual — F6 typically points to two or three candidate parts.
- Check wiring harness continuity to the suspect sensor before condemning it.
- Isolate at the fused spur, discharge and re-inspect connectors.
- Measure resistance / voltage at the PCB plug per Ideal test procedure.
Parts to have on the van
Carry a set of NTC sensors, an ignition electrode kit and a fan for Ideal — these three parts clear >70% of F6 call-outs.
Recommission
After the fix, run the Ideal boiler through a full flow test, gas rate, and combustion analysis. Log to the Benchmark book to preserve manufacturer warranty.
Frequently asked questions
- Can I reset F6 without changing parts?
- Only if the fault has cleared (e.g. low pressure repressurised). Persistent F6 means a hardware failure.
- Which is the most common cause of Ideal F6?
- On Ideal boilers, F6 most often points to the sensor or actuator matching its meaning (outdoor sensor); check wiring and connector integrity first.
- Is a Gas Safe engineer required?
- Yes — any works past the boiler case seal require a Gas Safe registered engineer under UK law.
Browse boiler spares — 14,820 live parts.
View Boiler Spares