How to Fix Potterton E317 Fault Code (50 Hz Supply Fault) UK
Potterton E317 means 50 Hz supply fault. UK diagnosis, parts to order, reset sequence.
What E317 means
Potterton E317 indicates 50 Hz supply fault. The boiler will lock out and refuse to fire until the fault is cleared.
Do not simply reset — E317 is stored in the Potterton error log and will re-trigger within minutes if the underlying part has failed.
Diagnostic sequence
Enter service mode on the Potterton boiler and read the flow/return/DHW temperatures, fan PWM, ionisation current and pump speed.
Cross-reference against the Potterton technical manual — E317 typically points to two or three candidate parts.
- Check wiring harness continuity to the suspect sensor before condemning it.
- Isolate at the fused spur, discharge and re-inspect connectors.
- Measure resistance / voltage at the PCB plug per Potterton test procedure.
Parts to have on the van
Carry a set of NTC sensors, an ignition electrode kit and a fan for Potterton — these three parts clear >70% of E317 call-outs.
Recommission
After the fix, run the Potterton boiler through a full flow test, gas rate, and combustion analysis. Log to the Benchmark book to preserve manufacturer warranty.
Frequently asked questions
- Can I reset E317 without changing parts?
- Only if the fault has cleared (e.g. low pressure repressurised). Persistent E317 means a hardware failure.
- Which is the most common cause of Potterton E317?
- On Potterton boilers, E317 most often points to the sensor or actuator matching its meaning (50 Hz supply fault); check wiring and connector integrity first.
- Is a Gas Safe engineer required?
- Yes — any works past the boiler case seal require a Gas Safe registered engineer under UK law.
Browse boiler spares — 14,820 live parts.
View Boiler Spares