Do I need to notify the manufacturer?

Only if the ATAG iC Economiser 27 is in warranty — ATAG require log of any part swap for labour claims.

How to Replace the Ntc Sensor on a ATAG iC Economiser 27 (UK)

Replace an NTC thermistor on ATAG iC Economiser 27 for wildly inaccurate flow temps or an F22/F75/L1 low-water fault.

Each NTC on ATAG iC Economiser 27 clips onto the copper flow pipe with a spring clip. Fit fresh heat-sink compound before refitting.

Cross-check resistance with a multimeter — 10 kΩ at 25 °C for standard blue-body NTCs.

Refill the ATAG iC Economiser 27 to 1.2 bar cold. Bleed high-point radiators and the internal AAV.

Run a full flue-gas analysis after 15 minutes. Log the reading against the OEM commissioning envelope in the Benchmark book.

Which colour?: Flow NTC is normally blue, return NTC red on ATAG iC Economiser 27. Do not swap.
Wire polarity?: NTCs are non-polar — but keep leads clear of ignition HT leads.
Do I need to notify the manufacturer?: Only if the ATAG iC Economiser 27 is in warranty — ATAG require log of any part swap for labour claims.

Shop the spares

Browse boiler spares — 14,820 live parts.