Why does the new one still weep?

Almost always the expansion vessel — check pre-charge first before condemning the PRV.

Only fit WRAS-approved 3-bar PRVs to keep ATAG iC Economiser 27 within its Gas Safe commissioning envelope.

Do I need to notify the manufacturer?

Only if the ATAG iC Economiser 27 is in warranty — ATAG require log of any part swap for labour claims.

Fit a new 3-bar PRV on ATAG iC Economiser 27 when water dribbles constantly from the outside discharge pipe.

Drain below the PRV, unscrew the old valve and fit new PTFE tape (10 turns clockwise).

On ATAG iC Economiser 27 the PRV sits on the hydraulic block — torque to 25 Nm to avoid cracking the plastic manifold.

Refill the ATAG iC Economiser 27 to 1.2 bar cold. Bleed high-point radiators and the internal AAV.

Run a full flue-gas analysis after 15 minutes. Log the reading against the OEM commissioning envelope in the Benchmark book.

Why does the new one still weep?: Almost always the expansion vessel — check pre-charge first before condemning the PRV.
Any WRAS approval?: Only fit WRAS-approved 3-bar PRVs to keep ATAG iC Economiser 27 within its Gas Safe commissioning envelope.
Do I need to notify the manufacturer?: Only if the ATAG iC Economiser 27 is in warranty — ATAG require log of any part swap for labour claims.

Shop the spares

Browse boiler spares — 14,820 live parts.