How to Replace the Pcb Display on a ATAG iC Economiser 35 (UK)
Step-by-step UK guide to replacing the user interface / display board on a ATAG iC Economiser 35. Part numbers, torques, commissioning.
ATAG
The part
Fit a new fascia display on ATAG iC Economiser 35 when the screen is blank, dim or the touch buttons no longer respond.
Isolate safely
The display board is separate from the main PCB on ATAG iC Economiser 35. It plugs in via a 6-way ribbon or JST connector.
Fit and commission
Handle by the edges — ESD damages the driver IC before you even fit it.
Recommission checklist
Refill the ATAG iC Economiser 35 to 1.2 bar cold. Bleed high-point radiators and the internal AAV.
Run a full flue-gas analysis after 15 minutes. Log the reading against the OEM commissioning envelope in the Benchmark book.
Frequently asked questions
- Do I re-enter installer settings?
- Yes — the display holds the language and clock; installer parameters live on the main PCB and persist.
- Is a firmware update needed?
- Only if the OEM display carries a newer part suffix (e.g. -02). Older firmware can throw comms faults with newer main PCBs.
- Do I need to notify the manufacturer?
- Only if the ATAG iC Economiser 35 is in warranty — ATAG require log of any part swap for labour claims.
Shop the spares
Browse boiler spares — 14,820 live parts.
View Boiler Spares