Inspect annually at service; replace at 5-year mark or after any freeze event.

No — use OEM only; the seal geometry on ATAG iC Economiser 35 varies between production years.

Do I need to notify the manufacturer?

Only if the ATAG iC Economiser 35 is in warranty — ATAG require log of any part swap for labour claims.

How to Replace the Siphon Trap on a ATAG iC Economiser 35 (UK)

Replace the condensate siphon on ATAG iC Economiser 35 for D5 / F1 pressure faults after a hard frost or heavy servicing schedule.

Isolate, drop the case front. Undo the siphon quick-release clip on ATAG iC Economiser 35, tip out old fluid.

Prime the new siphon with 250 mL clean water before refitting — dry siphons throw immediate flue-pressure faults.

Refill the ATAG iC Economiser 35 to 1.2 bar cold. Bleed high-point radiators and the internal AAV.

Run a full flue-gas analysis after 15 minutes. Log the reading against the OEM commissioning envelope in the Benchmark book.

Interval?: Inspect annually at service; replace at 5-year mark or after any freeze event.
Can I fit generic?: No — use OEM only; the seal geometry on ATAG iC Economiser 35 varies between production years.
Do I need to notify the manufacturer?: Only if the ATAG iC Economiser 35 is in warranty — ATAG require log of any part swap for labour claims.

Shop the spares

Browse boiler spares — 14,820 live parts.