Can I clean rather than replace?

Yes for a limescaled unit — soak the turbine in citric acid, but replace if the Hall-effect PCB is corroded.

What minimum flow triggers?

The Ideal Logic Plus 30 typically ignites at 2.5 L/min. Below that, check the aerator on the DHW outlet.

Only if the Ideal Logic Plus 30 is in warranty — Ideal require log of any part swap for labour claims.

Swap the DHW turbine on Ideal Logic Plus 30 when hot water runs cold at low flow or the boiler fails to fire on demand.

Isolate cold mains at the boiler's blue isolator. The sensor on Ideal Logic Plus 30 clips into the hydraulic block with two retaining clips.

Fit new O-rings and align the turbine so the flow arrow matches the cold mains direction.

Refill the Ideal Logic Plus 30 to 1.2 bar cold. Bleed high-point radiators and the internal AAV.

Run a full flue-gas analysis after 15 minutes. Log the reading against the OEM commissioning envelope in the Benchmark book.

Can I clean rather than replace?: Yes for a limescaled unit — soak the turbine in citric acid, but replace if the Hall-effect PCB is corroded.
What minimum flow triggers?: The Ideal Logic Plus 30 typically ignites at 2.5 L/min. Below that, check the aerator on the DHW outlet.
Do I need to notify the manufacturer?: Only if the Ideal Logic Plus 30 is in warranty — Ideal require log of any part swap for labour claims.

Shop the spares

Browse boiler spares — 14,820 live parts.