How do I set the max temp?

After fitting, run cold-only, then set the shroud to 38 °C, then hot. Rotate the stop-ring until 43 °C max is achieved at the outlet.

The Mira Advance ATL 9.0 cartridge is TMV2 approved out of the box. For TMV3 (healthcare) fit the -HC suffix variant.

OEM or aftermarket for Mira?

For TMV2/TMV3 compliance always fit genuine Mira cartridges. Aftermarket voids the Advance ATL 9.0 approval.

How to Replace the Thermostatic Cartridge on a Mira Advance ATL 9.0 (UK)

The part

Rebalance a scaling Mira Advance ATL 9.0 by swapping the OEM thermostatic cartridge — restores TMV2 approval and 38 °C set-point.

Isolate

Isolate hot and cold at the built-in EasyFit valves or dedicated isolators. Drop the pressure by opening the outlet fully.

Swap the thermostatic cartridge

Undo the temperature handle grub screw, remove the escutcheon and pull the cartridge with the OEM extraction tool — needle-nose pliers will crack the Mira plastic housing.

Commission

Balance hot and cold to within 0.5 bar. Run the Mira Advance ATL 9.0 at max flow for 3 minutes.

Verify max outlet temperature stays below 46 °C per BS EN 1111 by shutting off cold and reading the outlet.

Frequently asked questions

How do I set the max temp?: After fitting, run cold-only, then set the shroud to 38 °C, then hot. Rotate the stop-ring until 43 °C max is achieved at the outlet.
TMV3 compliance?: The Mira Advance ATL 9.0 cartridge is TMV2 approved out of the box. For TMV3 (healthcare) fit the -HC suffix variant.
OEM or aftermarket for Mira?: For TMV2/TMV3 compliance always fit genuine Mira cartridges. Aftermarket voids the Advance ATL 9.0 approval.

Shop the spares

Browse shower spares — 5,410 live parts.

View Shower Spares