PCB part number location?

On Ravenheat WH110 the PCB label is on the top-right of the board, printed as an 0005-series code. Match every digit.

Do I need to re-parameterise?

Yes — enter the correct boiler model code in the service menu after fitting so the ignition curve, fan speed and gas rate match.

Only if the Ravenheat WH110 is in warranty — Ravenheat require log of any part swap for labour claims.

Replace the main control PCB — the most common cause of no-heat, no-DHW and intermittent lockouts on Ravenheat WH110.

Isolate at the fused spur and lock off. Discharge any residual mains voltage before touching connectors.

Photograph every plug and its position on the Ravenheat WH110 PCB before unclipping — connector positions differ subtly across firmware revisions.

Refill the Ravenheat WH110 to 1.2 bar cold. Bleed high-point radiators and the internal AAV.

Run a full flue-gas analysis after 15 minutes. Log the reading against the OEM commissioning envelope in the Benchmark book.

PCB part number location?: On Ravenheat WH110 the PCB label is on the top-right of the board, printed as an 0005-series code. Match every digit.
Do I need to re-parameterise?: Yes — enter the correct boiler model code in the service menu after fitting so the ignition curve, fan speed and gas rate match.
Do I need to notify the manufacturer?: Only if the Ravenheat WH110 is in warranty — Ravenheat require log of any part swap for labour claims.

Shop the spares

Browse boiler spares — 14,820 live parts.