How do I set the max temp?

After fitting, run cold-only, then set the shroud to 38 °C, then hot. Rotate the stop-ring until 43 °C max is achieved at the outlet.

The Triton T90SR cartridge is TMV2 approved out of the box. For TMV3 (healthcare) fit the -HC suffix variant.

OEM or aftermarket for Triton?

For TMV2/TMV3 compliance always fit genuine Triton cartridges. Aftermarket voids the T90SR approval.

How to Replace the Thermostatic Cartridge on a Triton T90SR (UK)

The part

Rebalance a scaling Triton T90SR by swapping the OEM thermostatic cartridge — restores TMV2 approval and 38 °C set-point.

Isolate

Isolate hot and cold at the built-in EasyFit valves or dedicated isolators. Drop the pressure by opening the outlet fully.

Swap the thermostatic cartridge

Undo the temperature handle grub screw, remove the escutcheon and pull the cartridge with the OEM extraction tool — needle-nose pliers will crack the Triton plastic housing.

Commission

Balance hot and cold to within 0.5 bar. Run the Triton T90SR at max flow for 3 minutes.

Verify max outlet temperature stays below 46 °C per BS EN 1111 by shutting off cold and reading the outlet.

Frequently asked questions

How do I set the max temp?: After fitting, run cold-only, then set the shroud to 38 °C, then hot. Rotate the stop-ring until 43 °C max is achieved at the outlet.
TMV3 compliance?: The Triton T90SR cartridge is TMV2 approved out of the box. For TMV3 (healthcare) fit the -HC suffix variant.
OEM or aftermarket for Triton?: For TMV2/TMV3 compliance always fit genuine Triton cartridges. Aftermarket voids the T90SR approval.

Shop the spares

Browse shower spares — 5,410 live parts.

View Shower Spares