Descale up to 15% flow loss; replace beyond. Sentinel R200 works but takes 4 hours.

Vokera Easi-Heat Plus 25C uses a 10-plate or 14-plate HEX depending on rating — cross-check the model suffix.

Do I need to notify the manufacturer?

Only if the Vokera Easi-Heat Plus 25C is in warranty — Vokera require log of any part swap for labour claims.

How to Replace the Dhw Heat Exchanger on a Vokera Easi-Heat Plus 25C (UK)

Fit a new plate HEX on Vokera Easi-Heat Plus 25C when DHW runs lukewarm but CH temperatures are correct — classic scaled plate symptom.

Isolate mains cold and CH, remove the four Allen bolts and lift the plate HEX from the hydraulic block on Vokera Easi-Heat Plus 25C.

Fit new O-rings and grease with silicone; never re-use the old seals.

Refill the Vokera Easi-Heat Plus 25C to 1.2 bar cold. Bleed high-point radiators and the internal AAV.

Run a full flue-gas analysis after 15 minutes. Log the reading against the OEM commissioning envelope in the Benchmark book.

Descale or replace?: Descale up to 15% flow loss; replace beyond. Sentinel R200 works but takes 4 hours.
Plate count?: Vokera Easi-Heat Plus 25C uses a 10-plate or 14-plate HEX depending on rating — cross-check the model suffix.
Do I need to notify the manufacturer?: Only if the Vokera Easi-Heat Plus 25C is in warranty — Vokera require log of any part swap for labour claims.

Shop the spares

Browse boiler spares — 14,820 live parts.